Engr. Rommel N. Corona discusses the essentials of the industrial calibration equipment.
In compliance with the ISO 9001:2008 requirement on control of monitoring and measurement equipment, the University Quality Assurance Center (QAC) conducted a two-day Industrial and Dimensional Calibration Seminar-Workshop on August 31 –Sept. 1, 2016 at the New Board Room.
Participated by the Faculty and the Science/Mechanical Laboratory In-Charge of the Main and External campuses , the seminar enabled the participants to understand and explain the essential calibration principles and practices, identify common errors in calibration and its corresponding corrective measures, and the use, proper handling and maintenance of different calibration equipment.
Invited resource persons were Engr. Rommel N. Corona and Eng. Daniel Paul P. Aquino
of Metals Industry Research and Development Center—Department of Science and Technology (MIRDC-DOST).
ISAT U faculty and laboratory in-charge listen attentively to lectures. At the lower right corner of the photo are the instruments that will be used in the actual demonstration in calibration procedures.
